RSS Feed
Twitter
Friday, April 01, 2011
Designer
Tail is one component in a touch screen that functions to place the flow of electricity from the socket electrical panel to the touch screen. Can be regarded as a replacement cable or connector.
On the Tail sometimes there is to be connected between the circuit below (Glass) and the upper circuit (Film). To connect two circuit or connector is in need through holes.Here is a picture of a Tail Connector front and rear:
Through hole on the touchscreen component is the part that connects the front and Ag Ag rear. See the following figure illustrates this:
Meanwhile, to make the die cut in through the hole we have to make a marker at the four corners of the image as follows:
Next we make a hole trough hole that will be in pairs of nails. And nail holes will be producing an on the material. So at that time flowed Ag ink will seep into the back. Detail see drawing below:
The next step we decide to cut size of material. On the outer side of the cut size of material we attach a knife to cut. Limit or cut size range knives with blades we make 20 mm. Then the upper right of the material we make a knife cut to the corner marker size of 10 mm.
For more details try you see the picture below :
Function Corner marker cut the top right so as not to reverse the top and bottom when printing using Ag ink.
On the Tail sometimes there is to be connected between the circuit below (Glass) and the upper circuit (Film). To connect two circuit or connector is in need through holes.Here is a picture of a Tail Connector front and rear:
Through hole on the touchscreen component is the part that connects the front and Ag Ag rear. See the following figure illustrates this:
Next we make a hole trough hole that will be in pairs of nails. And nail holes will be producing an on the material. So at that time flowed Ag ink will seep into the back. Detail see drawing below:
The next step we decide to cut size of material. On the outer side of the cut size of material we attach a knife to cut. Limit or cut size range knives with blades we make 20 mm. Then the upper right of the material we make a knife cut to the corner marker size of 10 mm.
For more details try you see the picture below :
