Standard Setting Pattern (Analog Type)

(1)   Setting the Pattern Top Sheet and Bottom Sheet

Arrange so that the pattern in the Top and Bottom, a high surface resistance of short size. While the low surface resistance, long pattern size.

In the standard Normal Pattern ITO Long Top Sheet, Bottom Pattern ITO sheets while short.

(2) The position and size of pattern

① Width Pattern: Normal 2 ~ 3mm, most small 1mm. Make the pattern as thick as possible
(Reference: approx 5mm)
② Pattern Overlap: Overlap 0.5mm one side of the ITO pattern.
③ Position Pattern: From viewing AREA 0.5mm, Position on the outside of min 1.5 mm from the ACTIVE AREA. later, the same position with the opposite pattern.

If not use the ER (Etching Resistor) the composition of its pattern following: